Port, board and/or hardware

RP2, Board Arduino Nano Connect 2040 with NINA W102 module.

MicroPython version

MicroPython v1.24.0-preview.118.g5f3ecc29f on 2024-07-20; Arduino Nano RP2040 Connect with RP2040

Reproduction

Configure Webrepl, enable Wifi and start Webrepl at the board. Then connect with webrepl from a PC and enter the password. Content of main.py:

import station
import webrepl
webrepl.start()

station.py just starts wifi. webrepl_cfg.py and an empty boot.py exist.

Expected behaviour

Working webrepl

Observed behaviour

Webrepl works with firmware v1.23.0.
With v1.24.0-preview.118 (and earlier) the board locks up after entering the Webrepl password. Needs a hardware reset or power cycle to recover. Log:

network config: ('10.0.0.179', '255.255.255.0', '10.0.0.240', '10.0.0.240')
WebREPL server started on http://10.0.0.179:8266/
Started webrepl in normal mode
MicroPython v1.24.0-preview.118.g5f3ecc29f on 2024-07-20; Arduino Nano RP2040 Connect with RP2040
Type "help()" for more information.
>>> 
WebREPL connection from: ('10.0.0.150', 53812)
FATAL: uncaught exception 

UDP and TCP connections work, tested with iperf3.py.

Additional Information

No, I've provided everything above.

Code of Conduct

Yes, I agree