NUCLEO-H743ZI DFU mode failure
I can not get the H743ZI into DFU mode nor can I find anything about how to put the device into DFU mode other then ST-LINK V3 can do it if you have ST-LINK V3... I've read the information about how to generate other firmware BUT last night Microsoft upgraded my system with WSL Version 2, this morning I tried to get WSL Version 2 to work and not only failed but killed version 1, no Linux, nothting but the files I generated last night..
Nucleo H743ZI2 can not get to the REPL in thonny
I downloaded the firmware from the official release, both a few nightly releases and the stable 1.20 version. None of these could get me a REPL in thonny. I have tested these on 2 NUCLEO_H743ZI2 boards, neither of them worked. However, there is a serial port showing up in the windows device monitor.
I also own some NUCLEO F-Series boards (Nucleo F446RE and F411) and all of them works normally with the REPL. Could this be something ST-Link related? I have updated the ST-Link V3 on board to the newest firmware version, but before that, it didn't work neither.