GD25Q32EEIGR chip does not recognize the development board after burning the Micropython 1.25 firmware
Port, board and/or hardware
PICO2-nRF52840
MicroPython version
The problem is only with the microython firmware that is being burned to version 1.25. Everything works fine after the 1.24 version of the micropython firmware is burned.
Reproduction
Burn the latest version of the micropython firmware (i.e. version 1.25) for the PICO2-nRF52840, and the board cannot be recognized after burning.
Expected behaviour
Flash the latest version of the micropython firmware (i.e. version 1.25) for the PICO2-nRF52840.
Observed behaviour
GD25Q32EEIGR chip could not recognize the development board after burning the micropython 1.25 firmware, but everything worked fine after burning the 1.24 firmware.
Additional Information
No, I've provided everything above.
Code of Conduct
Yes, I agree
1.24 breaks USB OTG support
Port, board and/or hardware
ESP32S3
MicroPython version
1.23 / 1.24
Reproduction
Instll kernel, reset, see if it boots
Expected behaviour
Boots
Observed behaviour
Loading firmware 1.24 does not boot using USB-OTG. I don't have serial port. Just USB-OTG, so need kernel to default that on.
Loading firmware 1.23 works as expected.
Additional Information
No, I've provided everything above.
Code of Conduct
Yes, I agree